AROMA RECCOMENDED TO YOU

USEFUL SUGGESTIONS FOR THE CORRECT USE OF THE MACHINES

USEFUL QUESTIONS

SUGGESTIONS FOR THE CORRECT USE OF THE MACHINES
  • Check that the power socket is working;
  • If the problem persists, contact our assistance service;
  • We recommend that you contact our assistance service;
  • Check that there is water in the tank;
  • Check that the rear silicone tube is properly immersed in the water tank;
  • Descale your machine and clean all of the circuits (buy our Descaler);
  • If the problem persists, contact our assistance service;
  • Check that there is water in the water tank;
  • Check that the rear silicone tube is properly immersed in the water tank;
  • If the problem persists, contact our assistance service;
  • Check that the coffee pod is correctly positioned in its coffee pod holder during the brewing process;
  • Check that the pod press adheres perfectly to the inserted coffee pod until it closes perfectly;
  • Check that the o-ring is present under the pod press;
  • If the problem persists, contact our assistance service;
  • Check that the drip tray is intact and correctly inserted inside the machine;
  • If the problem persists, contact our assistance service;
  • Always use good quality pods with a suitable weight (ESE 44 mm):
    a pod with poor quality/quantity ground coffee consequently characterizes the result in the cup for a good coffee!
  • Adjust the brass pod press following the type of pod inserted in the machine;
  • If the problem persists, contact our assistance service;
  • Check that there is water in the tank;
  • Descale your machine and clean all of the circuits (buy our Descaler);
  • If the problem persists, contact our assistance service;
  • We recommend that you contact our assistance service;
  • With constant use of the machine, the upper part of the pod press can loosen or wear its O-rings, therefore it is advisable to replace the worn parts or to adjust the brewing group at our authorized service center.
  • If the problem persists, contact our assistance service;
  • Check that there is water in the tank;
  • Check that the rear silicone tube is properly immersed in the water tank;
  • Check that the silicone tube is not damaged;
  • If the problem persists, contact our assistance service;

IT IS GOOD TO KNOW THAT...

  • - It is important, after each brewing, to remove the pod from its housing: if you do not do it immediately after brewing the coffee, you risk also removing the o-ring along with the dry pod. If this happens, make the machine brewing for 3 seconds only with water with the lever open, so as to easily detach the dry pod.
  • The tank of your machine must be adequately filled with water, if you do not do it you risk damaging the brewing pump.
  • Proceed with a washing cycle of the brewing circuit once a month, with a suitable detergent. Do not use aggressive detergents and / or acids. We recommend our descaler and then follow the instructions on the label.
  • Remember that water contains calcium and magnesium salts which, when heated, can form limescale, harmful to all appliances, and therefore must be eliminated. The procedure for removing limescale should be repeated according to the use of the machine and the hardness of the water, approximately every 6 months and only has 3 simple steps. We recommend our descaler and then follow the instructions on the label.
  • We remind you that all defects caused by poor maintenance and / or use of your machine are excluded from the warranty, therefore remember to always carry out periodic cleaning and descaling!

DO YOU STILL NEED HELP?